On the structure of the transformer winding machine is mainly composed of the fuselage, frame, spindle body and tail frame support, frame and other components, due to the weight of the transformer coil has certain processing at the same time also need to bear the external force of knock plastic, so the coiling machine body and frame are used to withstand strong steel, according to the size of the machine processing capacity is divided into small, medium and large types, bearing capacity is not the same.

   Vendors would of transformer winding equipment use will also exist in the process of winding function Clinton, it because many factors influence the causes, this is to form a big influence on the production processing companies, the production decline, customers lost in question, such as large impact on manufacturer after is carried out, then presents the winding function Clinton conditions, demand what changes to processing, the following is an all-round introduction to:

Parts, when the transformer winding machine for goods processing, presents the winding function produce can not meet the practical requirement level, is associated with winding equipment parts a little, when winding equipment used in the process of continuously, processing goods are present will surely loss influence on the formation equipment as parts was badly damaged, merchandise coiling the level of demand, it is difficult to reach practice parts maintenance work needs to make the appropriate changes, surely not in cycle in maintenance operations in the future, but every time end of goods in the future, just in time to add smooth dose, slow parts wear condition, so can reduce the winding function status of the Clinton.

   When the transformer winding machine of factory of full automatic winding machine presents winding action to be not safe, be sure not to open the equipment privately to carry on the adjustment, it is very likely to present the question not to handle, but to add more use question, good is to carry on the corresponding mode operation through the professional staff of the manufacturer.

The inaccurate parking position of the spindle is usually caused by brake failure. For example, brake pad loose, or brake pad wear caused. It is also related to the setting of the braking time. If the braking time is too short, the parking position of the spindle will be inaccurate. Brake pads need to be replaced or replaced. Adjust brake time.

    Automatic winding machine factory transformer winding machine such as the occurrence of counting is not allowed, generally due to the sensor, or controller hardware problems, such a situation transformer winding machine can not work, is generally notify the manufacturer for maintenance.

修改翻译结果